Installation & splicing
Backbone, riser and horizontal fiber pulled to design, with fusion splicing for low-loss permanent joints and enclosures sized for future strand capacity.
Service
Fiber Optics
Backbone that carries everything else. We install, splice, terminate, test and document single-mode and multimode fiber for commercial, industrial and data center environments.
Overview
Fiber built to be tested, not just pulled
A fiber run is only as good as its weakest connector. We treat termination and testing as the deliverable, not the afterthought — every strand is spliced, tested and recorded, and you get the results in a form your team can actually use for troubleshooting later.
Whether the job is a campus backbone between buildings, a riser feeding IDF closets, or high-strand-count trunks inside a data hall, the work follows the same sequence: design the pathway, pull clean, terminate properly, test to standard, label and hand over documentation.
Photo slot — fiber optics
Capabilities
What this covers
FO-01
FO-02
Testing & certification
Insertion loss and OTDR trace testing against the applicable standard, with pass/fail results captured per strand rather than per bundle.
FO-03
Troubleshooting & repair
Fault location on existing plant, emergency splice repair, and re-termination of runs that were never tested or documented correctly the first time.
Scope of work
Included in fiber optics projects
- Single-mode fiber
- Multimode fiber
- Fiber backbone installation
- Fusion splicing
- Mechanical termination
- Fiber patching
- Pathway & innerduct
- Fiber testing
- OTDR testing
- Fiber certification
- Fault location
- Fiber repair
- Labeling schemes
- As-built documentation
Related
Often installed together
Start a project
Get a quote for fiber optics.
Send plans, drawings or a scope description and we will price the work.